VMD 139
Detector for cracks
Kit that allows you to locate with precision and ease all defects found on welds or die cast
of metal elements with no damaging effects on surfaces, for an effective quality control. It
consists of three products that must be used in conjunction to detect any holes, pits, fatigue
cracks and porosity within the weld.
DIRECTIONS FOR USE
1) Degrease and clean the entire surface to be verified using the CRACK CLEANER VMD
137
2) Apply to the surface a thin layer of RED CRACK PENETRANT VMD 138 and wait 15-20
minutes to allow the liquid to act
3) Remove the excess of RED PENETRANT using again the CRACK CLEANER VMD 137
and let the surface dry out
4) Finally, spray the WHITE CRACK DETECTOR VMD 139 and let it act for a few minutes.
Now, red traces will appear at the points where there are metal defects, allowing the
operator to fix them.
Kit that allows you to locate with precision and ease all defects found on welds or die cast
of metal elements with no damaging effects on surfaces, for an effective quality control. It
consists of three products that must be used in conjunction to detect any holes, pits, fatigue
cracks and porosity within the weld.
DIRECTIONS FOR USE
1) Degrease and clean the entire surface to be verified using the CRACK CLEANER VMD
137
2) Apply to the surface a thin layer of RED CRACK PENETRANT VMD 138 and wait 15-20
minutes to allow the liquid to act
3) Remove the excess of RED PENETRANT using again the CRACK CLEANER VMD 137
and let the surface dry out
4) Finally, spray the WHITE CRACK DETECTOR VMD 139 and let it act for a few minutes.
Now, red traces will appear at the points where there are metal defects, allowing the
operator to fix them.
VMD 139
16 other products in the same category:
Detector for cracks